MicroFlex MidKnight� Black Nitrile
Black Nitrile (non-latex) disposable gloves offer a distinct look for the user!
An exceptional combination of performance, comfort and durability.
MidKnight gloves are slightly thinner than our other MicroFlex offerings, but they are still sufficient for most finishing shop requirements. The distinct black color helps mask transfer from stains and dyes.
Fully textured fingers and palms offer an enhanced grip while handling parts.
These gloves are NON-POWDERED and are the preferred choice to prevent surface contimation of parts prior to finishing. Powders can stick or transfer to surfaces, resulting in un-even finishing results.
- Powder-Free to prevent surface contamination.
- Textured fingers & palms for good grip.
- With rolled cuff for ease of use
- Resistant to most shop solvents including alcohol, acetone and lacquer thinners.
- Ambidextrous, packaged in boxes of 100.
Material: Nitrile, Powder-Free, Polymer Coated
Exterior: Fully Textured (except XXL - fingers only)
Length (mm/in): 245 / 9.6
Cuff Thickness (mils): 3.1
Palm Thickness (mils): 4.7
Finger Thickness (mils): 5.5
Tensile Strength (MPa): 16
Elasticity (%): 550%
Size gloves by placing hand firmly on a table over tape measure or ruler and measure the widest part of palm.
My hand measures about 105mm; I wear "Large" from the following chart...
Glove Sizing Chart (approximation)
85-97mm (3.3-3.8 in)
97-110mm (3.8-4.3 in)
110-122mm (4.3-4.8 in)
+122mm (+4.8 in)