Target Coatings HSF5100 is a high solids, thermoset urethane grain filler formulated for application by trowel, brush or spray.

Specifically engineered to provide a smooth, non-textured appearance on open grained woods like Oak, Ash, Walnut, Mahogany, etc.
 

Available as a neutral colored filler that can be used directly on light colored woods or tinted to suit darker woods as required. Apply filler directly over bare wood if desired or over pre-stained, sealed surfaces.
 

Brush and wipe filler into grain/pores and allow to set for 5 to 10 minutes. Squeegee off excess and allow to dry for 2 hours. Level sand with 400 grit paper and re-apply filler if required or proceed to remainder of finishing schedule.
 

The fast drying nature of this system allows topcoats to be applied in as little as 2 hours of initial dry-to-touch time with any water-based topcoat finishing system.

• Low VOC
• Water Clean-Up
• Non-Flammable
• Tintable with ColorFX Dyes, Mixol Pigments or UTCs to create matching or contrasting grain patterns
• Spray, Brush or Wipe on